lubricating oil造句

1、The state of the fuel oil,lubricating oil, cooling fresh and sea water, and bilge system.(燃油、滑油、冷卻水、海水和艙底水系統的情況。)

2、They have paid close attention to the market for mid-gradelubricating oil and have adopted the strategy of "cutting into the sales of mid-gradelubricating oil".(外國石油公司已經密切關注中檔油市場，開展了“下攻中檔油”的策略。)

3、The result showed that the removal rate of this type of gelling agent to gasoline, diesel oil, kerosine andlubricating oil was higher than 90%.(結果表明，此類凝油劑對汽油，柴油，機油以及基苯及苯系有機溶劑等的去除率達90％以上。)

4、The optimal weight fraction is 0.1%, for under this condition, the wear scar diameter is decreased 35.6% andlubricating oil has great time-release effect.(當銅鎳復合粉體的質量分數達到0.1%時，磨斑直徑降低幅度最大，達35.6%，并具有很好的長效減摩性能。)

5、In the paper, the Neural Network model of metal content mainly monitored in thelubricating oil monitoring system of aeroengine is built by the method of Neural Network.(利用神經網絡方法對某型航空發動機滑油監控系統中需重點監控的金屬元素含量建立了網絡，并根據該模型對其含量變化趨勢進行了預測分析。) hao86.com

6、An airplanelubricating oil injection gun comprises an oil storage cylinder plug (1), a decomposed joint (2), a cloth clamping hose (3) and an oil injection nozzle (4).(一種飛機滑油注油槍，其包括儲油筒堵頭(1)、分解接頭(2)、夾布膠管(3)、注油嘴(4)。)

7、With the increasing soot level contaminatinglubricating oil, the oil viscosity increase and wear of engine components become more severe. And it shortens the life of engine.(柴油機油引起的粘度增長不僅縮短了柴油機的使用壽命，而且增加了零部件的磨損。)

8、In this paper, the design of both the software and the hardware of the computer control system for the test-bed oflubricating oil system for aeroengine are discussed explicitly.(本文詳細討論了航空發動機滑油系統試驗臺計算機控制系統的軟、硬件設計的過程和方法。)

9、lubricating oil of the low pressure system supplies the main and other bearings.(低壓系統的滑油供給主軸承和其它軸承。)

10、The application of time-series modeling and forecasting method to the spectral analysis forlubricating oil of mechanical equipment is discussed.(討論了時序建模與預測方法在機械設備滑油光譜分析中的應用。)

11、The article forlubricating oil into dry gas seal reason is analyzed.(本文針對干氣密封一次進油事故原因進行了分析。)

12、With CD40lubricating oil as work medium, under the engine cooling system work conditions, 21 geometrical schemes of stainless steel offset strip fins were studied.(采用CD40柴油機油為工作介質，在發動機冷卻系統實際工況下，對21種幾何尺寸的錯列鋸齒型不銹鋼翅片進行了研究。)

13、Taking DF4B locomotive as an example, this paper analyses the reason of too lowlubricating oil pressure in running diesel engine, and gives countermeasures for it.(以DF4B型機車為例，系統地分析了造成柴油機機油壓力低的原因，并提出其判斷方法和對策。)

14、The testing process was used CD40lubricating oil and CD40lubricating oil appending nano-Cu additive.(試驗結果證明納米銅添加劑能夠有效改善柴油機的磨合質量，縮短磨合時間。)

15、The toxicity oflubricating oil and grease 'chiefly stem from additives and stuff. Its main harm is dermatitis.(潤滑油、脂的毒性主要來源于添加劑和填充物，其主要危害是皮炎。)

16、It is one of the most important problems to assurelubricating oil of returning to the compressors all the time.(保證冷凍油源源不斷地返回壓縮機是制冷系統設計中最重要的課題之一。)

17、As thelubricating oil passes over a hot engine part, it removes a certain amount of heat.(當機油經過發動機的熱的部件時，它將帶走一定量的熱量。)

18、In this paper, we discuss the applications of time series modeling method in the analysis oflubricating oil of mechanical equipment.(本文討論了時序建模方法在機械設備滑油光譜分析中的應用。)

19、Afterwards in meets in the fast box the replenishment 20lubricating oil.(隨后在接速箱內加注20號機械油。)

20、Three preparation methods for fluorocarbonlubricating oil and its properties and applications are introduced in this paper.(介紹了全氟碳油的產品性能及應用情況。)

21、The problems such as noise, abnormal sound, heat andlubricating oil leakage of front gear box of DF 8b locomotive are analyzed in detail.(對東風8B型機車前變速箱存在的噪音、異音、發熱和機油泄漏等問題，進行了詳盡的分析。)

22、Test results proved that, in the process of using oil, the light oil content inlubricating oil can be judged from the decreasing degree of flash point.(試驗證明：在油品使用過程中，從閃點的下降程度可以判斷混入輕質油的含量。)

23、lubricating oil inside the engine produces a film on the moving parts.(發動機內部的機油在運動部件上形成一層膜。)

24、The higher the normal load, the smaller the effect of thelubricating oil inlet temperature and rolling speed on the traction coefficient.(隨著載荷增大，入口油溫和滾動速度對拖動系數的影響減小；)

25、Fuel oil andlubricating oil sy stems including pumps, purifiers, filters, heaters.(滑油管系，包括泵、分油機、濾器、加熱器和管系狀況滿意，無泄漏。)

26、lubricating oil is designed to effectively carry away the excess heat being produced.(機油有效地帶走發動機多余的熱量。)

27、Previously, this problem was avoided by using a large amount oflubricating oil during machining.(為解決這一問題，以往是使用大量切削油進行切削加工。)

28、Alubricating oil pump shaft and a CAM transmission shaft are respectively sheathed in series in two inner cavities.(兩內腔內分別串套機油泵軸和凸輪傳動軸。)